Storage

»  During the storage, the panel is put in 10 degree of inner leaning position.
»  Plywood is put on the bottom as a base plate for a stack. There are no more than 100     pieces of panel lay down in the plane position for each stack.
»  Panels are put in pairs i.e. top surface to top surface, bottom surface to bottom surface     for one and nearby.

Transportation

»  During the transportation. The panel is put in the position of 10 inner leaning degree     and handled up and down by two persons. Never push and pull the panel in order to      prevent from being hurt.
»  Never move the panel when in the flat position. During the transportation don't put the     heavy solid on the panel to prevent it from being bent or caved in.
»  Before the processing, clean the working desk and take any solid out to prevent the     panel from being damaged.

Note

»  Batch wise colours may differ.
»  Please ask for samples.
»  Subject to change without notice.
»  For further information, Samples, Technical Information please contact our area sales     manger or marketing department.

Suggestions

»  To ensure colour consistency. The total requirement for a project is advised to be      placed in one order.
»  It is also recommended to install the panels in the same direction as marked arrow on     the protective peel off film to avoid possible reflection differences.
»  Custom colours are also available upon request for solid colours, Metallic colours and    special finishes such as mirror, brush finishes. Etc. subject to respective minimum      quality.